|
Small common sense of adding refrigerant in Summer.
HFC=134a is a new type green refrigerant,
chemistry name: 1,1,1,2 molecular formula: CH2FCF3. It is innocuous,
colorless, no-burning, no-exploding with stable heating stability and
chemistry features. Comparing with CFC-12, the ODP is O with stronger
refrigeration ability. The boiling point is -26.15℃.
It is the ideal substitute of CFC-12.
There are
some unqualified R-134a refrigerant in the present market. The outside
marking is R-134a but actually it is F-12 or the blend of two with more
water-containing and acid-container which will accelerate the hardening
and damage of cooling system and gasket and results leakage on
refrigeration parts. High water-containing will cause poor lubricating
cooling pumps, and prick up abrasion, while water will freeze in
refrigeration system to block refrigerant circulation and influence
refrigeration effect. If use F-12 refrigerant to imitate R-134a and add
to cooling system, Since F-12 refrigerant and R-134a refrigerant cooling
oil can’t dissolve, this will cause badness of cooling pump lubricating
and block to lose refrigerant function, then waste more cost to repair
refrigeration system.
Botny
R-134a Refrigerant fluid come from ICI. Coming from gentlefolk will
guarantee superior quality which ensure you to pass every hot summer,
the quality index is as follows:
Purity
99.99%
Water
content
0.0008%
Acid
content
<0.00001
Boiling
point: ℃
-26.1
vaporizing
residual
0.002%
破坏臭氧潜能值（ODP）
0
全球变暖系数值（GWP）
0.29
It
is using aluminum can for packaging, aluminum can belongs to single
patch can, while iron can belongs to three-path can. So there is no
welding line existing like on iron can, and will not happen explode in
welding line. The explosive pressure for iron can used to packing
refrigerant is 1.6Mpa commonly while aluminum can used by Botny to
packing refrigerant is 3.0Mpa. Thus it is more safe to use high-pressure
resistant aluminum can to can high pressure explosive products. |
